scalebion.blogg.se - Coppercube flooring

#Coppercube flooring manual#
#Coppercube flooring full#
#Coppercube flooring portable#
#Coppercube flooring zip#

#Coppercube flooring portable#

Local network storage drive OR external USB storage (either flash drive or portable hard drive).The following equipment is needed before going on-site to perform a backup: If your automatic backup was not successful, try backing up manually.ĬopperCube Firmware 1.21 and Later Required Hardware components.

#Coppercube flooring zip#

Other signs of an unsuccessful backup include finding empty folders or incorrect files in the zip file.

#Coppercube flooring manual#

If you can unzip the file, your backup is successful, otherwise, you will need to use the manual backup process.

Connect the Storage Device to your Laptop and try to unzip the backup file.

– If the message displays an error, please try backing up again.įollow the steps given below to check if the backup was successful: – If the message displays a success, you can unplug the storage device.

Once the Backup is completed, one pop-up message will appear on the top right-hand side of the page.

Access the Database Backup and Restore page in the CopperCube user interface.

Manual BackupĪfter you’ve completed the backup setup as described in the previous procedure, you can back up your CopperCube at any time using the following procedure: Automatic Backup Process for the CopperCubeĪfter you’ve completed the backup setup as described in the previous procedure, the CopperCube will back up according to the schedule you’ve set up. You are now ready to back up your CopperCube.

Select how often you want to back up (if you plan to only backup manually the CopperCube, input a date different than the current day).

Select the type of Backup: Settings Only (Configuration) or Settings and Data (Configuration and Data).Ĭaution: Backing up data can create a large file (several GB).

If the USB storage device is not recognized and does not appear on the list, unplug it and try another port.

Click to highlight the USB storage device from the backup device list.

Click the Enable / Disable Database Backup to check the option box.

Click Settings and then Backup and Restore.

Log on using the CopperCube username and password.

Access the CopperCube graphical user Interface by entering the CopperCube IP address in the address bar of the web browser.

If you are using a laptop, connect your laptop to the diagnostic port (LAN 2) of the CopperCube.

Make sure this is the only USB device on the CopperCube.

Plug the storage device into a USB port of the CopperCube.

Software: A web browser to access the CopperCube graphical user interfaceįollow the procedure below to back up your CopperCube:.

Laptop or operator workstation specifications: Using a slow device only makes this process a lot more painful.

Minimum write speed of 50MB/sec The backup will be very large and the time taken can be significant.

The following are the minimum requirements for USB storage:

Laptop, or operator workstation connected to the same network as the CopperCube and web browser installed.Įxternal USB storage technical specifications:.

In addition, a spare USB storage device is recommended.

External USB storage (either flash drive or portable hard drive).

CopperCube Firmware 1.11, 1.20 Required Hardware Componentsīefore going on site, you must be prepared with the following: CopperCube Firmware 1.69 (1.06)Ĭontact Technical Support about backing up this firmware version. The Backup file can contain only the Configuration of the CopperCube or the Configuration and the archived Data.

#Coppercube flooring full#

The CopperCube backup feature allows the user to create a full or partial backup file of the CopperCube.